-
SX1 blokiran
Please HELP
I tried to update my Siemens sx1 to svn 15 official, and incorrectly dissconnect the cable.
Tried with
Popravak SX1
Evo što trebate napraviti ukoliko ste krivo flash-ali SX1 i sad ga ne možete startati...
Prvo što Vam treba jest odgovarajući Winswup za Vaš SX1. Winswup skinite negdje na Internetu; a moja je preporuka allsiemens.com
Kad ste jednom dosli do Winswup-a; sljedeće što trebate napraviti jest podesiti postavke u programu kako slijedi:
1) FLASHING RADITI SA COM KABELOM (x55)
POSTAVKE PARAMETARA U WINSWUP-u
MANUAL SWITCH
115200 BAUD
INFO O KOMBINACIJI..
EGOLD
CORE - DA
BOOT - NEAKTIVAN
OMAP
ALL PARAMETR - ISKLJUCENO
PRIKLJUCITI KABEL
KLIKNITI NA START
SLIJEDI PORUKA - CONNECT BOOTBOX
STISNITI - OK
SAD STISNITI JOYSTICK PREMA DOLJE I U ISTO VRIJEME UKLJUCITI MOBITEL
FLASHING ZAPOCINJE....
KAD OVO ZAVRSI, UPDATE-ajte SX1 SA FIRMWARE-OM!!
ZA OVO KORISTITI SAMO ORIGINALNI USB KABEL
UKLJUCITI SVE PARAMETRE U EGOLD-u
To je to - sad je Vaš SX1 opet u pogonu
and still nothing
On winswup says " No Bootcore detected "
Can you please advise, and help me.
Xeni
-
Did you have correct cable? Orginal Siemens for series x55 is not valid. You must use non-orginal cable.
-
Yes,
I have both of them, I was using X55 NONE ORG cable ( ne-originalni kabal )
Xeni
-
Sljaka
I'm ready to go out and work, but I would like to speak with you on msn
xenigj@hotmail.com
-
Sljaka,
I fixed it with freia 15, write full flash to phone SIE/SX1/8MB/LG07/V700800000, and then I will put a new firmware.
Many thanks
Xeni
-
If I understand corectly, you fixed your SX1.