SX1 blokiran

[xeni]

Please HELP
I tried to update my Siemens sx1 to svn 15 official, and incorrectly dissconnect the cable.
Tried with
Popravak SX1

Evo što trebate napraviti ukoliko ste krivo flash-ali SX1 i sad ga ne možete startati...

Prvo što Vam treba jest odgovarajući Winswup za Vaš SX1. Winswup skinite negdje na Internetu; a moja je preporuka allsiemens.com

Kad ste jednom dosli do Winswup-a; sljedeće što trebate napraviti jest podesiti postavke u programu kako slijedi:

1) FLASHING RADITI SA COM KABELOM (x55)

POSTAVKE PARAMETARA U WINSWUP-u
MANUAL SWITCH
115200 BAUD

INFO O KOMBINACIJI..

EGOLD
CORE - DA
BOOT - NEAKTIVAN

OMAP
ALL PARAMETR - ISKLJUCENO

PRIKLJUCITI KABEL
KLIKNITI NA START
SLIJEDI PORUKA - CONNECT BOOTBOX
STISNITI - OK

SAD STISNITI JOYSTICK PREMA DOLJE I U ISTO VRIJEME UKLJUCITI MOBITEL
FLASHING ZAPOCINJE....

KAD OVO ZAVRSI, UPDATE-ajte SX1 SA FIRMWARE-OM!!
ZA OVO KORISTITI SAMO ORIGINALNI USB KABEL
UKLJUCITI SVE PARAMETRE U EGOLD-u

To je to - sad je Vaš SX1 opet u pogonu

and still nothing
On winswup says " No Bootcore detected "

Can you please advise, and help me.

Xeni

[Sljaka]

Did you have correct cable? Orginal Siemens for series x55 is not valid. You must use non-orginal cable.

[xeni]

Yes,
I have both of them, I was using X55 NONE ORG cable ( ne-originalni kabal )
Xeni

[xeni]

Sljaka
I'm ready to go out and work, but I would like to speak with you on msn
xenigj@hotmail.com

[xeni]

Sljaka,
I fixed it with freia 15, write full flash to phone SIE/SX1/8MB/LG07/V700800000, and then I will put a new firmware.
Many thanks
Xeni

[Sljaka]

If I understand corectly, you fixed your SX1.