investigate the pros following the flashing
1st Controls the status of your lock-Stars. It may not be available SIM-lock!
Lock status in order to check the KEYPADfollowing code: * # 7465625 #
The ad must be SIM-Lock OFFView, otherwise it will flash the phone rendered unusable by the!
second Controls whether the PC Studio and the New SAMSUNG USB drivers are installed correctly. The NPS must be in connection to the USB in PC studio mode can correctly recognize the Star. If not, the flash will not work.
3rd Makes a complete backup of your personal information (contacts, photos, music, video, etc.) before flashing. When you flash your data is all deleted!
4th Make sure that the battery before flashing stars is completely charged, too!
Quote:
For flashing you will need:
1st The included Samsung USB data cable
second Properly installed NPS (see above)
third The Flash program: Multi-Loader 5.60
4th A decompression program: WinRAR ( click! ) or 7-zip ( click! )
5th The new firmware: available FWs watch list
Flash operation
1.Ends the NPS and the small tool next to the Clock!
2.Download the desired FW down and unpacked with WinRAR or 7-zip to a folder.
3.Turn out the Star, remove the SIM card and mircoSD.
4.press off Star on all three buttons: volume down - camera key at the same time - on / off / end call button until the display one red barwith the word DOWNLOAD white text appears on.
5.Restarts the Multi Loader
6.Selects under CONTROLthe Star BRCM2133of.
7.Set the hook at FULL DOWNLOAD.
8.on click BOOT, and marks the BOOT / BOOT FILES folder in the folder containing the unzipped firmware and then click OK.
9.is similar in APPS, RSRC1, RSRC2and Factory FS proceed.
AMSS , TUNE , FOTA and ETC remain empty.
CAUTION:If there are 2 versions of a file type always chooses the LOW version , otherwise there is a risk that the phone will not start more correctly.
10.Connects the Star with the USB cable to the PCs
11.Click on the multi loader PORT SEARCH. The Star is found at the port and it shows the message READY.
12.clicks on DOWNLOADand is now off the flash process. This information is constantly running in the right box appears.
13.If the message "All Files complete"will flash process is finished.
14.disconnects the phone from USB. If your phone does not automatically restart, remove the battery and puts it on again.
15. Invokes the star and leads a final MASTER RESET through.
This in KEYPADthe code * 2767 * 3855 # to enter and wait briefly.
16.After a final reboot give in KEYPADthe code * # 1234 #, and checks the New FW version.
NAPOMENA:OVO NIJE MOJ VODIĆ I COPY/PASTE JE SA DRUGE STRANICE,NISAM ODGOVORAN AKO SI POKIDATE MOB....
I da,99% ekipe ovo radi,pa nema previše brige,osim ak baš upadnete u onaj 1% xD
Sretno s flashanjem i moddanjem
Prevest ću guide u toku današnjeg dana,a linkove očekujte koji drugi dan
Odgovori uz citat
Bookmarks