Eto mali tutorial, mogu prevesti, ali sada nemam vremena, pa recite ako treba prievod uopče..

3.5mm adapter
Cut and open up, there are 3 wires (red, green/blue and yellow)

red = earth
green/blue = right ear
yellow = left ear

miniUSB/EMU adapter
Cut and open up, separate out the wires. There are 6 wires (red, black, green, white, gold, silver). Carefully strip off the rubber housing on the red, black, green and white wires to expose a bit of the copper underneath.


Moto handsfree
Use a flat screwdriver and ply open the top panel carefully.
Once opened up take out the pcb and cut away all the connecting wires. Pull out the wire stopper at each end and put them on both your adapters before soldering.
From the top view:


We can begin soldering now:
1. Solder the RED wire on the 3.5mm adapter to point 8. (Earth)
2. Solder the GREEN wire on the 3.5mm adapter to point 7. (Right ear)
3. Solder the YELLOW wire on the 3.5mm adapter to point 2. (Left ear)
4. Solder the RED wire on the EMU adapter to point 3.
5. Solder the WHITE wire on the EMU adapter to point 4.
6. Solder the GREEN wire on the EMU adapter to point 5.
7. Solder the BLACK wire on the EMU adapter to point 6.
8. Flip the pcb over. Solder the GOLD wire on the EMU adapter to the point under the BLACK wire point (6).
9. Solder the SILVER wire on the EMU adapter to the point under point 1.

Ok you are done. I hope my description is clear enuff. Assemble everything back together and your adapter should be ready to use! There is no need to edit the gain table as the sound is now properly amplified.